vusolo2


Vu+ Solo2

Flash an image via USB


  1. Format your USB stick with a FAT32 file system
  2. Download the USB image of your choice on http://openpli.org/download/vuplus/vusolo2/
  3. Extract the USB image (it is a .zip archive) on your PC using your favorite unzip tool to the root directory of your USB stick. The result is that you get a directory vuplus and in this directory you find a directory solo2 in which you find the necessary files.
  4. Insert the prepared USB stick into the front of your VU+ Solo2 receiver
  5. Switch your VU+ Solo2 off (power-off, not stand-by!). Or choose restart in your receiver: Menu -> Standby / Restart -> Restart and go directly to step 7
  6. Switch your VU+ Solo2 on
  7. After powering on the Solo2 you see: Starting. If the USB-stick is properly recognised you will see the following text (alternating) Update! Press Power
  8. During the showing of the above text press the power button (on the receiver!) The text will be shown about 5-8 seconds.
  9. After the flash procedure the Solo2 will be rebooted automatically. If not switch the power off and on again to reboot.


Please bear in mind: To flash an image there may be only one USB-device connected with the receiver and that's the USB-device with the image you want to flash. If there are more USB-devices connected the flash procedure will most likely fail and won't even start!

There are no comments on this page.
Valid XHTML :: Valid CSS: :: Powered by WikkaWiki