E2Tuner


Revision [3153]

This is an old revision of E2Tuner made by jonc on 2008-11-17 02:44:09.

 

Howto setup / add and configure my tuners and satellites

Seup your DVB -S-C-T or S2 tuner(s)

Click here for the E1 Generic Menus


Select the tuner you have installed or want to use with this setup (you can have more than 1 tuner set up so make sure you select the right one) with your arrows keys and the OK button on your remote control.

sat

Once you have defined your tuner type (DVB-S example below) this setup up screen for your satellite(s)
will be shown. We will below go through the set up and give examples of the changes you may need to
make for the LNB settings in your part of the world.

There are 4 major settings here with 10 minor settings.

sat

1. The first thing you need to do is define the satellite you are going to use. You can simply highlight the
Satellite row and press either your right ot left arrows to change the satellite name. Please beware that
since the release of the Pli Jade software, all satellites are included in this option so you can set up
the satellite of your choice no matter where in the world you are.

A small word of warning for C/Ku band users of the same satellite: With the current set up of the
satellites.xml file you are UNABLBE to select both the C & Ku band setup of the same satellite (unless
you do a manual edit of the satellites.xml file).

2. Voltage mode: If you have a fixed dish or move dish just plugged straight into your DM box
then you will leave this setting as it shows. For other setup you can change this;

3. Tone mode: If you have a fixed dish or move dish just plugged straight into your DM box
then you will leave this setting as it shows. For other setup you can change this;

Note: similar to the 22hz setting on an E1 box


4. LNB: This is the LNB to be used with the satellite selected above, and will have the associated
properties below. Once you have set this up you can change the properties or simply change to another
LNB number with different properties.


4a. LNB: Diseqc mode This setting will set up your LNB to act in different ways.



- under construction -





Examples of a Multiswitch setup;

Seup your satellites



sat

sat

sat

sat

sat

sat


we want your input

we are looking for E2 contributors for E2 howto's please PM WanWizard or jonc

back 1 page : Back to the PLiĀ® Wiki Home Page : DM7025 : DM800
There are no comments on this page.
Valid XHTML :: Valid CSS: :: Powered by WikkaWiki