E1Satconfig


Revision [784]

This is an old revision of E1Satconfig made by jonc on 2008-06-08 04:24:43.

 

1st step of setting up the dish.


choose_diseqc
This is the satellite configuration screen. Here we can choose three possible settings. No disecq for one satellite, simple for up to 4 satellites and the complex configuration for a disecq motor or the complex configuration of a wavefrontier dish with up to 16 satellites.

In our case we choose a simple configuration like a Dish with up to four satellites. Normally the Hotbird sat is disecq A and Astra is diseqc B. In our example usually the Astra 2 satellite is at 3 and a fourth satellite is depending of your own choice. At the pictures below is shown how to do this.

Satelliteconfiguration
Satellite configuration


Once you set this up press the GREEN button to Save your changes, if you need to change anything else you can do it later under the Menu Button, Setup, Satellites & Transponders, Satellite Configuration

* add new NA diseqc set up *


Tip: You can at anytime go back to these screens and make any changes you require Click here to learn howto make these changes


Back to the PLiĀ® Wiki Home Page : Generic Howtos : DM500 : DM500+ : DM56xx : DM600 : DM7000 : DM7020 : DM7025 : DM800
There are no comments on this page.
Valid XHTML :: Valid CSS: :: Powered by WikkaWiki